DiabloSport EAS Wideband Input Cable for Trinity 2 and Edge CTS Monitors - 98622

The DiabloSport EAS Wideband Input 98622 is a plug-in accessory cable that takes the analog output from a wideband oxygen sensor controller and shows air/fuel ratio as a gauge on a DiabloSport Trinity 2 or an Edge CTS series monitor. It does not include a wideband sensor or controller.

Because the AFR signal comes in through the monitor, it is recorded in the same data log as the OBD-II channels, so you can check a tune under load without a laptop in the passenger seat and review the log afterward in DiabloSport's DataViewer software.

Compatible monitors and required hardware

• DiabloSport Trinity 2 and Trinity 2 EX
• Edge CTS2, CTS3 and CTS4 displays (Insight, Evolution and Juice versions) through the EAS accessory chain
• Requires a wideband controller with a 0-5 volt analog output, sold separately
• On a CTS series display the EAS chain starts with the EAS Starter Kit cable 98602; the Trinity 2 has the EAS port built in

What it does

• Puts live air/fuel ratio on the monitor as a selectable gauge
• Logs AFR alongside RPM, load and the other OBD-II parameters
• Plug-and-play EAS connector; no splicing into the monitor harness
• Daisy-chains with other EAS accessories such as pressure and temperature sensors

Installation and limitations

Connect the cable to the EAS port on the Trinity 2, or to the end of the EAS chain on a CTS display, and wire the two signal leads to the analog output and ground of your wideband controller. Select the AFR channel on screen. For a two-channel 0-5 volt input on a CTS display, see the EAS Universal Sensor Input 98605.

Specifications

• Part number: 98622
• Brand: DiabloSport
• Warranty: 1 year manufacturer warranty
• Country of origin: United States
• Packaged size: 9.5 x 6.3 x 1.5 in, 2 lb
• UPC: 810009935858

Frequently asked questions

Does this include the wideband sensor?

No. It is the input cable only. You need a wideband controller with an analog output, for example an Innovate or AEM gauge controller, which supplies the sensor.

Will it work on an inTune i3?

No. The i3 and Trinity T1000 use the T1015 analog pigtail instead. The 98622 is for the Trinity 2 and Edge CTS monitors.

Can I log the AFR?

Yes. The channel is recorded in the monitor's data log with the OBD-II data and can be reviewed in DataViewer.