DiabloSport Analog Sensor Pigtail 0-5V Two Channel for Trinity T1000 and inTune i2 i3 - T1015

The DiabloSport T1015 is a two-channel 0-5 volt analog input cable for the inTune i2, inTune i3 and Trinity T1000. It lets any sensor or controller with a 0-5 volt output, such as a wideband AFR controller, be displayed and logged on the device together with its OBD-II data.

Common uses are a wideband controller, an EGT amplifier, or a fuel pressure sender when you want to see them on the same timeline as RPM and engine load.

Compatible devices

• DiabloSport inTune i2 and inTune i3 (plugs into the accessory jack on top of the device)
• DiabloSport Trinity T1000
• Not for the Trinity 2, which uses the EAS system and the EAS Wideband Input 98622 instead

What it does

• Two channels, each with a bare signal lead and a ground wire
• Accepts any 0-5 volt analog output
• Readings are displayed as channels and recorded in the device data log with the OBD-II stream
• Plug-in connection at the device end; the sensor end is wired to your controller

Installation and limitations

Plug the cable into the jack on top of the inTune or Trinity T1000, connect the signal and ground leads to your sensor or controller output, and configure the channel scaling on the device. The leads are bare wire, so you supply the connector or splice for your sensor.

Specifications

• Part number: T1015
• Brand: DiabloSport
• Warranty: 1 year manufacturer warranty
• Country of origin: United States
• Packaged size: 4 x 4 x 4 in, 1 lb
• UPC: 718122445653

Frequently asked questions

Does it come with a sensor?

No. It is the input cable only. The sensor or controller with a 0-5 volt output is sold separately.

Can I run two sensors at once?

Yes. Each of the two channels has its own signal lead and ground, so you can log two inputs at the same time.

Is this for the Trinity 2?

No. The Trinity 2 uses the EAS accessory system. This cable is for the inTune i2, inTune i3 and the original Trinity T1000.