PROLINK Cable for MPVI2

Log your wideband and boost sensors on an MPVI2. The PROLINK cable plugs into the HPTNET port on an MPVI2 and gives VCM Scanner two analog inputs and one CAN input, so you can record external sensors right alongside the vehicle's own data.

• Two 0-5 volt analog inputs for sensors such as a wideband oxygen controller or MAP sensor
• One CAN bus input at 500 kbps
• 100 Hz sampling
• HPTNET male connector to a 5-wire flying lead

Compatibility

This cable is for the original MPVI2 only, and the MPVI2 must have the Pro Feature Set enabled. The MPVI2+, MPVI3 and MPVI4 use the PROLINK+ cable instead.

Running more than one vehicle? Keep a PROLINK installed in each and move the interface between them.